I keep getting an inside-out bullet with the design program

DoubleJ
Posts: 1
Joined: Mon Oct 01, 2018 8:59 am

I keep getting an inside-out bullet with the design program

Postby DoubleJ » Mon Oct 01, 2018 9:13 am

I'm attempting a powder coated and gas checked boolit for my .458 SOCOM with no crimp groove or lube grooves. It's basically a copy of the Hornady 325 FTX in all dimensions except for the cannulure, poly tip, and base. Everything is fine until I choose 'no crimp groove' At that point, I get lube grooves that I can't get rid of, and if I try to put in the correct numbers on the bottom, I end up with a picture of the boolit that is inside out.

Can I just put 'no crimp groove' in the comments?

Who's checks should I use a shank for? The platform is an AR-15.

User avatar
mtngun
Site Admin
Posts: 1639
Joined: Fri Feb 01, 2008 5:45 pm
Location: Where the Salmon joins the Snake

Re: I keep getting an inside-out bullet with the design program

Postby mtngun » Tue Oct 02, 2018 5:58 am

The bottom half of the program is output-only.

There is no option for smooth bullets. They serve no purpose.


Return to “design & sizing”

Who is online

Users browsing this forum: No registered users and 4 guests

cron